The Console and indicator diagnostic test on a Whirlpool Cabrio washing machine is used to check the cycle selector knob, console indicators, user interface buttons, two-digit display, and beeper. 1. The washing machine should be in standby (off) mode. 2. Press and release the following buttons within 4 www.doorway.ruted Reading Time: 10 mins. Have a look at the manual Whirlpool Cabrio User Guide online for free. For example, you may hear a clicking and hum at the beginning of the cycle, as the lid lock goes through a self-test. There will be different kinds of humming and whirring sounds as the washplate moves the load and as the basket is slowing down to stop. Lighter soil. TEST #8 Door Lid Lock. 1. Perform Manual: Door Switch and Manual: Door Lid Lock tests. 2. Remove the console to access the machine/motor control assembly. See Accessing Removing the Electronic Assemblies. 3. Visually check that the P12 connector is inserted all the way into the machine/motor control. If visual check passes, go to step 4.
The Console and indicator diagnostic test on a Whirlpool Cabrio washing machine is used to check the cycle selector knob, console indicators, user interface buttons, two-digit display, and beeper. 1. The washing machine should be in standby (off) mode. 2. Press and release the following buttons within 4 seconds. CLEAN WASHER or DRAIN SPIN Turns on recirculation pump, the indicator is steady on. Repeat Turns off the recirculation pump, the indicator turns off. Repeat Turns on the drain pump, indicator flashes. Repeat Turns off drain pump, the indicator turns off. Models With Cycle Selector: Select CLEAN WASHER or DRAIN SPIN. Press and release. How to set a Cabrio washing machine to spin only.
Cabrio washer models Whirlpool Cabrio Washing Machines WTWSW0, WTWSW1, If the diagnostic test mode has been successfully inserted, all. Khordad 3, AP For your washer to fill sufficiently, the water inlet valve needs a pressure of at least 20 psi from the home water supply. To test the pressure. I ran a manual test of the pump to remove the water, a test of the lid switch (checked good), Rotor Position Sensor (checked bad - no lights) and Spin.
0コメント